I'd just like to add that I have eliminated the SoftRAID volume locked error and sleep issues on my Mac by fully removing the Thunderbolt enclosure fr...

@softraid-support Good news, all 4 blades were certified and working fine. I'm not sure why SoftRAID reported one blade was missing or damaged a co...

@softraid-support Thanks for the tip. I ran AJA System Test Lite from the Mac App Store and also Blackmagic Disk Speed Test and the throughput is c...

@softraid-support I was able to start the certify process in the SoftRAID app. No need to delete the volume, but a reboot helped since I guess the v...

@softraid-support Ok, a little OT but I attempted to certify the blades. I had to use 'sudo diskutil unmount ' to unmount it. The SoftRAID app woul...

@softraid-support I ran this command using the softraidtool from my old startup volume as requested. Hope it helps.

@softraid-support Thanks for the reply. I created a new APFS volume on my startup disk as you recommended and reinstalled macOS on it. Then I was a...

@softraid-support Sounds like good advice... I would gladly try to certify the blades if I could only get SoftRAID up and running again on my Mac. ...

@softraid-support Just a correction - the Thunderbay 4 uses Thunderbolt 2 which maxes out at 10Gb/s, so assuming the same drives are used, a NAS conne...

@softraid-support It's been a busy few days for me. I managed to get my new NAS up and running and migrated my data. SMB is much slower than Thunde...

@softraid-support I'm getting a little concerned because I'm currently unable to use the SoftRAID application to monitor both the Thunderbay 4 and ...

@softraid-support I downloaded the latest DMG (6.2.1b13) over wifi on my phone and copied it to my Mac. After installing, I allowed the extension...

@softraid-support Thanks for the instructions. I followed the steps and was able to uninstall the 6.2.1 b12 driver and reinstall 6.2. I only ha...

@softraid-support I guess I disabled the menu bar icon in the app before I upgraded because I don't see it anymore and there are no SoftRAID proces...

@softraid-support It shows this version: com.softraid.driver.SoftRAID (6.2.1b12) The drive was quarantined so I ran this command to remove it f...