Yes and yes. When you cancel a certify, then certify the same disks, SoftRAID will try to pick up where it left off. Thank you for the confir...

The rebuild preference is why it was not rebuilding. We will investigate what you reported, and see if it is an issue. (rebuild switching from one ...

OK... While the manual Rebuild was underway on Vol 1 I went to SoftRAID Preferences -> RAID tab and found the "Automatically rebuild RAID volum...

I did exactly as you described. The auto Rebuild did not start. Here's the SoftRAID display showing this state after having completed all the steps yo...

Can I just pull one of the 4 disks out of its enclosure and place a new Initialized/Certified disk in its place and have the Rebuild start automatical...

So if it's supposed to be automatic, should I file a Problem Report ? What log files would you need ?

Thank you. That is exactly what I'm seeing. So I'm correct that the Rebuild is not automatic when I insert the new disk. It has to be started manually...

As some further information.... My AJA test were conducted after having filled the disks to about 69% full. This can obviously make a big differenc...

Thanks for your response and good advice information. I did as you suggested. I unmounted all 4 disks/volumes. I then ran a SoftRAID Verify o...