Notifications
Clear all
Topic starter
I can not see SMART data in Softraid, even though I have followed the directions and removed USB drives, rebooted, and waited a few minutes before pluging them in.
I also have DriveDX installed, and it's driver sees the SMART data from the USB connected RAID drives and (non-OWC) enclosure.
I am not sure what the issue might be. All the other features seem to work fine so far (except 16K blocks, but I know that's a separate issue.)
Any suggestions?
Posted : 07/05/2022 11:35 am
This is Monterey, correct?
We are working on supporting this, it is in a feature request in our environment.
Posted : 07/05/2022 2:45 pm
Topic starter
Yes, Monterey.
OK, then. Thanks for the info.
Posted : 07/05/2022 3:00 pm
